Power supply⁣⁣⁣⁣⁣⁣⁣

Indoor AC/DC injector IDU-CPE-G(24W)

IDU-CPE-G(24W) is an indoor Gigabit PoE injector which supports 100-240 V input range from the AC mains. IDU-CPE-G(24W) feeds 48 VDC power to the device by injecting it to the CAT5 Ethernet cable.

Parameter
Description

Compatible models

Astra Quanta and Astra Evolution (except E5-BSQ), AUX-ODU-SYNC

Size and weight

97x53.5x33.5 mm, 0.133 kg

Connectors and Interfaces

  • "LAN" - Ethernet input (Data only)

  • "POE" - Ethernet output (Data+VDC), PASSIVE PoE

  • "PWR" - AC Input

Supported Ethernet Modes

10/100/1000 Mbps

Standards

  • IEEE 802.3 10Base-T

  • IEEE 802.3U 100Base-TX

  • IEEE 802.3ab 1000Base-T

Input Power Requirements

  • AC Input Voltage: 100 ... 240 VAC

  • AC Input Current: 0.75 A

  • AC Frequency: 50 to 60 Hz

Consumption

28 W

Operating temperature range

-10 °С ... +40 °С

Operating humidity

Maximum 95 %, Non-condensing

Storage temperature

-40 °С ... +70 °С

Output Power Voltage

48 VDC, 0.5 A

Safety

UL cUL, CE, GS, CCC, FCC, S-MARK, PSE, C-tick, KC(48V0.5A) BIS(24V1A

Ethernet Connectors Pin-out

Pin
LAN
POE

1

A+

A+

2

A-

A-

3

B+

B+

4

C+

C+

5

C-

+VDC/ C-

6

B-

B-

7

D+

-VDC / D+

8

D-

-VDC / D-

Indoor DC/DC injector for all Astra Wireless' units with integrated lightning protection IDU-LA-G(V.01)

IDU-LA-G(V.01) is an indoor DC/DC injector. It greatly reduces complexity of the deployment in the cases where DC source is available thus reducing both capital expenditures and total cost of ownership.

IDU-LA-G(V.01) may be used for the following purposes:

  • To serve as a line protection unit for indoor network equipment connected to the second Ethernet port on ODU.

  • To connect third-party DC power sources to ODU (for example, to power the unit from solar power or wind power sources).

Technical parameters

Parameter
Description

Compatible models

Astra Quanta, Astra Evolution, Astra Quasar

Output Voltage

The same as input

Supported Ethernet Modes

10/100/1000 Mbps (Gigabit Ethernet pass-through)

Pin assignment and polarity

1/2 (+), 3/6 (-), 4/5 (+), 7/8 (-)

Size and Weight

115×65×40 mm, 0.15 kg

Operating temperature range

From 0°С to +40°С

Connectors description

Mounting holes sizes

IDU-LA-G(V.01) Packing List

Cable assembly

Lightning Protection Unit with Injector AUX-ODU-INJ-G

Optional indoor/outdoor DC injector with built-in lightning protection. It greatly reduces complexity of the deployment in the cases where DC source is available on the rooftop eliminating the need of weather-sealed cabinets. AUX-ODU-INJ-G is compatible with all Astra Wireless devices.

Parameter
Description

Size and Weight

34x94x121 mm, 0.28 kg

Connectors and Interfaces

  • ETH IN - Ethernet input

  • ETH OUT - Ethernet output (data+VDC, protected leg)

  • PWR - DC Input

  • GND - Ground clamp

Supported Ethernet Modes

10/100/1000 Mbps (Gigabit Ethernet pass-through)

Water and Dust Protection

IP66 and IP67

Operating temperature range

-55 °C ... +60 ºC

DC Range

±43...±56 VDC

Lightning Protection

In compliance with:

  • GR-1089

  • IEC 61000-4-2 (ESD) 15kV (air), 8kV (contact)

  • IEC 61000-4-4 (EFT) 40A (tp = 5/50ns)

  • IEC 61000-4-5 (Lightning) L5, 95A (tp = 8/20us)

  • ETSI ETS 300 386

Ethernet Connectors Pin-out

Pin
LAN
POE

1

Data pair A+

Data pair A+

2

Data pair A-

Data pair A-

3

Data pair B+

Data pair B+

4

Data pair C-

+VDC + Data pair C-

5

Data pair C+

+VDC + Data pair C+

6

Data pair B-

Data pair B-

7

Data pair D+

-VDC + Data pair D+

8

Data pair D-

-VDC + Data pair D-

Packing List

AUX-ODU-INJ-G is supplied with a worm clamp TORRO 40-60/9 C7 W4 DIN 3017 - 2 pcs. The clamp is made of stainless steel A4, width 9 mm, allows the installation on a mast with a diameter of 35 to 60 mm. In case of mast diameter more than 60 mm, a similar clamps (up to a 230 mm diameter) with a width of up to 12-13 mm can be used.

Last updated