Hardware Platform
Wireless device
The wireless device contains both the radio and networking electronics. Implemented in a robust all-weather metal enclosure, this equipment can be used to create point-to-point wireless links at long distances. The wireless device is supplied in the following configurations:
with removable integrated antenna 26 dBi (QSR5-26 / QSR6-26);
with removable integrated antenna 29 dBi (QSR5-29 / QSR6-29);
connectorized (waveguide to coaxial adapter required) (QSR5-Ep / QSR6-Ep).
The enclosure has 4 ports:
1x 2,5 Gigabit Ethernet port (10/100/1000/2,5G Base‑T), RJ‑45 connector: Data + Power.
1x 10 Gigabit SFP+ port: Data.
1x SYNC port - for connection external synchronization device*.
1x DC IN port - for powering the device directly from a DC source.
NOTE
Power and wired statuses indication is performed via glassy plug of the cable gland for ETH, SFP and SYNC ports.
Flash
Initialization
The LEDs on ETH and SFP ports light up with white on second. Then LEDs check is performed: red, blue, green are lightened up sequentially.
Flash
Loading
Only for ETH port: at the beginning green is lightened a few seconds, on the second loading stage switches to blue.
ON/Blue
Power
Only for ETH port.
ON/Green
Speed 1000 Mbps
ON/Light Blue
Speed 2500 Mbps
Only for ETH port.
ON/White
Speed 10000 Mbps
Only for SFP port.
ON/Green
ERConsole stage
Port with the established link lights up with green, the second port remains blue.
ON/Red
Speed 10 Mbps
Only for ETH port.
ON/Yellow
Speed 100 Mbps
Only for ETH port.
*Pending.
Last updated